Xprt Louvre Gun
This "game changer" tool connects to your standard 8mm pole tube (standard for professional window cleaners) via a push-fit fitting. Simply supply water from a DI tank or other pure-water source, and you’re ready to rinse away dirt and grime in no time.
Feel the satisfaction of really clean louvre windows without the struggle.
Once you’ve used the Louvre Gun, you’ll actually look forward to cleaning houses full of louvres — because you’ll know how to clean them fast, easy, and without a single smear.
This "game changer" tool connects to your standard 8mm pole tube (standard for professional window cleaners) via a push-fit fitting. Simply supply water from a DI tank or other pure-water source, and you’re ready to rinse away dirt and grime in no time.
No more tedious squeegeeing and detailing! Just scrub, rinse, and let the windows dry naturally.
Key Features:
• Individually quality tested to ensure reliable performance and a leak-free experience
• Plug-and-Play Design: Connects directly to 8mm (outer diameter) pole tubes for quick setup
• Convenient Thumb Trigger: Easy on/off control for efficient water usage
• Trigger lock-on: Prevent muscle fatige
• Replaceable Nozzle: Extend the life of your tool with simple nozzle replacements
• Designed by Professionals: Created by window cleaners, for window cleaners - and serious DIYers.
This must-have louvre window cleaning tool saves you time while achieving spotlessly shinning glass louvres! Built by people who’ve done the long, hard days themselves.
LENGTH: 230mm (9 inches)
HEIGHT: 85mm (3 inches)
WIDTH: 30mm (1 inch)
WEIGHT: 125 grams
1. Set Up and Protect the Area
-
Attach am 8mm hose to the louvre gun.
-
Check the connection is tight (no leaks).
-
Place towels or dropsheets below the louvres to catch drips.
-
Test the water flow away from the work area first.
-
The ideal water pressure can be determind by holding down the trigger and pointing the tip of the tool upwards. You want to see water bubbling gently out the top of the tip. If the water is spurting high above the tip, the pressure is too strong - turn it down a bit.
-
For spotless results, pure water TDS reading should be 000ppm.
⚠️ Water Pressure Note:
Each time you stop the water flow, pressure builds up in the hose. When you press the trigger again, please be prepared for an initial strong burst of water.
2. Wash the Louvres
-
Use a wet XPRT louvre mop to wash 3-4 louvre panels at a time (too many = water dries too fast = cloudy finish).
3. Rinse Properly
-
Start at the TOP MIDDLE of the louvre.
-
Slide the nozzle side-to-side until all glass surface has been rinsed off.
Key Reminders:
Test the spray first – Expect a strong initial burst.
Work in small sections (3–4 panels) – Helps prevent drying spots.
Rinse thoroughly – For a streak-free, clean finish.
If the trigger ever feels sticky, remove the plastic end cap under the yellow trigger, pull out the spring and pin, apply a small smear of silicone tap lubricant or plumber’s grease to the pin, reassemble. Do not use WD-40 or petroleum greases.
| SKU | XPRTLG |
|---|---|
| Weight | 0.500000 |
| Brand | Xprt |
